Airvo™ 2 Nasal

High Flow system

Designed to deliver proven* respiratory support

*A review of studies comprising the body of NHF evidence found the majority used F&P Optiflow™ systems

myAirvo for long-term/home care

Airvo 2, a humidified Nasal High Flow system
designed to treat your patients across the
care continuum.

Transportable

A system with a built-in flow generator means there’s no need for a noisy, heavy air compressor in order to use the Airvo 2 for transport. Add a UPS and you’re ready to go.

Broad flow range

A broad flow range (2 to 60 L/min) takes your patients from the most acute environments (ICU and ED) to the home.

Variety of interfaces

A variety of interfaces specifically designed with Optiflow High Flow therapy in mind.

At higher flows comfort is paramount - you need an interface designed for the job.

Our newest interface, Optiflow 3S

1. Controlled oxygen

Add and titrate oxygen separately from flow rate.

From .21 (room air) to 1.0.

FiO₂ displayed onscreen.

2. 93% less condensate*

AirSpiral™ heated breathing tube with integrated dual-spiral heated wires and temperature sensor.

No separate temperature probes or adapters required.

* When compared with the 900PT501 Airvo tube in internal Fisher & Paykel Healthcare testing.

3. Adjustable temperature

Three temperature settings, 37, 34, 31 °C.

4. Transportable

Mobile pole, oxygen bottles and transport kit designed for a UPS.

Setting up for transport

Airvo 2 instructional videos

Introduction

(5.05 mins)

Part 1 of the Airvo 2 video guide describes what the Airvo 2 is, how it works, and the philosophy behind the use of an active heated humidifier to provide Optimal Humidity.

Setup

(3.37 mins)

Part 2 of the Airvo 2 video is a step-by-step guide to setting up the Airvo 2, and an introduction to our range of interfaces.

Use

(6.03 mins)

Part 3 of the Airvo 2 video guide shows how to operate the Airvo 2, including how to adjust key settings such as flow, temperature, and how to add supplemental oxygen (if required).

Reprocessing

(5.25 mins)

Part 4 of the Airvo 2 video guide shows you how to clean and disinfect the Airvo 2; reprocessing it through high-level disinfection for use on the next patient.

Airvo 2 quick guides

What is the
Airvo 2?

(1.12 mins)

Fitting the Optiflow™ + Nasal Cannula

(1.55 mins)

Setting and changing temperature and flow

Setting Temperature and Flow rate

(2.01 mins)

Adding Oxygen

(51 sec)

Changing to Junior mode

(33 sec)

Onscreen troubleshooting

(28 sec)

Interface and breathing tube use period

(41 sec)

New Optiflow/Airvo Resources